Encode 300 - Accessing the UI

Encode 300 - Accessing the UI

Setup Information
  1. Plug in your Source (HDMI/HD-SDI/Serial (Component/Composite)
  2. Plug in your Ethernet Cable
  3. Plug in the Power
      At this point the unit should do the following:
  1. The unit will start up with a blinking Green power LED on the front of the unit
  2. Next the Video in LED will begin to flash Green
  3. After about 3-5 minutes the unit will hold a steady Green light on both the Power & Video LED's
      You should move on to configuring the unit and computer/laptop to access the software GUI
  1. Default IP Address: 192.168.1.1
  2. You should direct connect to the device with a standard Category Cable
  3. Configure your computer/laptop address to an IP Address between 192.168.1.2 - 192.168.1.255, Subnet Mask of 255.255.255.0 and the Default Gateway should be left blank
  4. Turn off your Wifi if it's on
  5. Open up a suitable web browser: Internet Explorer/Chrome/Firefox
  6. Type into the web browser https://192.168.1.1/ (Be sure that you include the S on the http for a secure connection)
  7. The Log In screen should appear for the device
  8. Default Password for the Log In screen: 1qaz!QAZ
  9. That will take you to the Dashboard of the unit
If you need more information on how to change the IP Address/Subnet of the Unit, Configure a Video Stream, Save Default Configurations, etc.  Please see related article Encode 300 - Advanced Configuration