Z-RF Encode 001 - Accessing the GUI

Z-RF Encode 001 - Accessing the GUI

Setup Information
  1. Plug in your Source (HDMI/HD-SDI/Serial (Component/Composite)
  2. Plug in your Ethernet Cable
  3. Plug in the Power
      At this point the unit should do the following:
  1. The display on the front of the unit will turn on
  2. Give the unit approximately 1 minute to complete initial power on
      You should move on to configuring the unit and computer/laptop to access the software GUI
  1. Default IP Address: 10.1.10.200
  2. You should direct connect to the device with a standard Category Cable
  3. Configure your computer/laptop address to an IP Address between 10.1.10.1 - 10.1.10.255 other than 10.1.10.200, Subnet Mask of 255.255.255.0 and the Default Gateway should be left blank
  4. Turn off your Wifi if it's on
  5. Open up a suitable web browser: Edge/Chrome/Firefox
  6. Type into the web browser http://10.1.10.200/
  7. The Log In screen should appear for the device
  8. Default Username for the log in screen: admin (case sensitive)
  9. Default Password for the log In screen: Admin123 (case sensitive)
  10. That will take you to the Overview tab of the UI